Special Metals Primer
Preparation
- All surfaces must be clean and dry.
- Remove loose rust, flaking paint and the gloss from old paintwork by wire brushing and/or rubbing down with coarse abrasive paper.
- Treat any rusted patches with Hammerite Kurust.
- Degrease thoroughly with a detergent solution then rinse thoroughly with clean water and allow to dry.
If using with a roller on large flat surfaces you may find it necessary to thin 10% with water. Do not use cellulose thinners or white spirit.
Application
- Stir paint thoroughly.
- Do not apply when there is a risk of rain, frost or if the temperature falls below 5degC.
- Hammerite Special Metals Primer is touch dry in 30 minutes (depending on weather conditions) and can be overcoated after only 2 hours.
- Hammerite Special Metals Primer can be overcoated with most paints.
Touch dry in 30 minutes, recoatable after 2 hours.
Cleaning & Storage
After use, remove as much paint as possible from brushes before cleaning with clean water.
