Hammerite Direct To Rust Metal Paint Aerosol Smooth Finish

Hammerite-Ultimate metal protection.
Size
Paint Calculator
This product is not for online sale and can only be purchased from selected stores.
Your Measurements:
Amount Needed:
For the best result we recommend to use {coatAmount} for {productTitle}
Key information
  • Finish Smooth finish
  • Coverage Aerosol - 400ml covers up to 0.5m²
  • Drying Time Aerosol - Touch dry in 1-2 hours, recoat after 15 minutes (wet-on-wet)
  • Coats 3
Product Features
  • Direct to rust

Product Description

Hammerite Direct to Rust Smooth Metal Paint is specially formulated to perform as primer, undercoat and topcoat in one

Application Description

Store aerosol at room temperature for 2 hours prior to use. Shake can vigorously, in a vertical motion, until the agitator ball is heard and then for a further 3 minutes.Apply light even coats, from a distance of approximately 15cm (6 inches) and keep the aerosol moving. Do NOT concentrate spray in one spot. Apply 3-4 coats for maximum protection and allow 15 minutes between coats. Between coats invert can and spray for 2 seconds to avoid blockages

Health & Safety

"Flame, Exclamation mark Danger. Contains HYDROCARBONS, C6-C7, N-ALKANES, ISOALKANES, CYCLICS,less than 5% N-HEXANE. Extremely flammable aerosol. Causes skin irritation. May cause drowsiness or dizziness. Harmful to aquatic life with long lasting effects. Pressurized container- may burst if heated. Keep out of reach of children. If medical advice is needed, have product container or label at hand. Wear protective gloves. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Do not get in eyes, on skin, or on clothing. Do not pierce or burn, even after use. IF INHALED- Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER or doctor if you feel unwell. Protect from sunlight. Do not expose to temperatures exceeding 50 degrees C/122 degrees F. Dispose of contents and container in accordance with all local, regional, national or international regulations. May produce an allergic reaction"
Hazard information can vary based on the colour of a product. Please choose a colour to see the relevant health and safety guidelines for this product.

Tips & Advice

  • 1. Preparing the Surfaces
    Abrade smooth surfaces and remove all loose and flaking paint with a wire brush. Remove dirt and dust with diluted detergent. Remove grease with Hammerite Brush Cleaner & Thinners. Then rinse with clean water and allow time to dry. Spray a test patch of Hammerite Direct to Rust Metal Paint onto painted surfaces and leave for at least 1 hour. If there is no reaction apply Hammerite Direct to Rust Metal Paint directly to surface. If there is a reaction remove all paint from the surface.On bare zinc, aluminium and galvanised surfaces, apply Hammerite Special Metals Primer before applying Hammerite Direct to Rust Metal Paint
Fetching the data, please wait...