Hammerite Radiator Enamel Gloss Aerosol
Hammerite-Ultimate metal protection.
Your Measurements:
Amount Needed:
For the best result we recommend to use
{coatAmount} for {productTitle}
-
Finish Gloss
-
Coverage 0.5m2per litre
-
Drying Time Touch dry in 1-2 hours, recoatable in 15 minutes (Wet-on-wet)
-
Coats 4
-
Long lasting gloss finish
-
Tough & durable
Product Description
Hammerite Radiator Enamel is specially formulated to provide a heat resistant, brilliant white finish on domestic water filled household radiators and hot water pipes.Provides a tough long lasting finish
Application Description
Store aerosol at room temperature for 2 hours prior to use. Shake can vigorously, in a vertical motion, until the agitator ball is heard and then for a further 3 minutes. Apply light even coats, from a distance of approximately 15cm (6"), and keep the aerosol moving. Do not concentrate spray on one spot. When touch dry (15 minutes) apply a further 2-3 coats, allowing 30 minutes between coats. Do not overspray as sagging may occur if excessive paint is applied. Between coats invert can and spray for 2 seconds to avoid blockages.
Health & Safety
Tips & Advice
-
1. Preparing the SurfacesAll surfaces must be clean, dry and free from rust, flaking paint, dirt, dust and grease. Rub down all painted surfaces with abrasive paper. Radiators must be turned off and only painted when cold. Mask off the surrounding area to protect from overspray
How much paint do I need?
More than one wall to paint? Try our advanced paint calculator
Measure the height and length of the surface you want to paint (in metres or centimetres).
Your Measurements:
{{!-- This value will be injected with JavaScript --}}
Amount needed:
{{!-- This value will be injected with JavaScript --}}
This is an estimated based on 2 coats. Actual coverage will depend on the conditions of the surface. If the colour change is strong, more coats may be required.
More than one wall to paint? Try our advanced paint calculator